JmenuGUIs

From SBS wiki
Jump to: navigation, search
RC phone: 757-876-1787
Crew chief: x7045
Operator 1: x7046
Operator 2: x7047
GMn Contact Information
Shift Schedule
Shift checklist
Hall A Phone Book
SBS Shifters Wiki Info
Documentation
HOW TOs for shift crew
Expert Tools

<<SBS Main<< HOW TOs (Bringing up main GUIs)

Hall A Status GUI

To bring up the Hall A Status screen from the jmenu GUI, type "hall a status" into the search and select "Hall A Status". The screen should look like the one pictured below.

HallAStatusScreen.png



Wall Accelerator Status GUI

To bring up the Wall Accelerator Status screen from the jmenu GUI, type "accel status wall menu" into the search and select "Accel Status". The screen should look like the one pictured below.

AcceleratorStatusScreen.png



Hall A General Tools GUI

To bring up the Hall General Tools GUI from the jmenu GUI, type "halla general tools" in the search bar and select "Hall A Counting House Tools Display". The screen should look like the one below.

HallAgeneralToolsGUI.png

Hall A Target FSD Masking GUI

To bring up the target masking GUI from jmenu navigate to FSD>>FSD Overview. When the FSD GUI pops up select the "Target Masking Screens" button and select "Hall A Target Movement Masking Screen". It should look like the GUI below (target is unmasked).

TargetMaskingGUI.png

Hall A Vacuum GUI

To bring up the Hall A vacuum GUI that monitors from the shield wall to the target from jmenu type "vacuum hall a shield to target" in the search bar and select "Hall A - Shield Wall to Target". It should resemble the GUI below.

HallAvacuumShieldWalltoTarget.png

BigBite GUI

To bring up the BigBite controls GUI, in the jmenu search bar type "bigbite" and select "BigBite (old version)". The GUI should look like the picture shown below.
BigBiteGUI.png

SuperBigBite (SBS) GUI

To bring up the SBS controls GUI, in the jmenu search bar type "sbs" and select "SBS correctors". The GUI should look like the picture shown below.
SBS GUI.png

High Voltage (HV) GUI

TO open the HV controls GUI from any terminal type

ssh -Y aslow@adaqsc
go_hv
This should open a GUI like the one shown below. Clicking on the buttons will open the HV controls for the various systems in different tabs.
HV GUI.png
.

Threshold Controls GUI for BBCal and HCal

To open the threshold controls GUI in any terminal type

 ssh -Y sbs-onl@adaq1
 cd /adaqfs/home/sbs-onl/hcal/GUI.

Set the environment variables:

 source setup.sh

Execute the following command to open the DAC control GUI:

python3 DAC_Control_GUI.py

After executing the command, the a new DAC GUI should pop up which has instructions to load, initialize and save the settings and adjust the thresholds. The terminal in which the command was executed should also print the previous settings of all the channels. DAC Control GUI.png

Scaler GUI

To bring up the Hall A Scaler GUI, which displays the scalers from the BigBite SHower Trigger sums, beam line, and trigger, ssh to a-onl@adaqX (X = 1, 2, 3, etc) type:

goxscaler

Then type ./xscaler SBS or ./xscaler Left. Note that the BigBite shower trigger is called TS1-BB and the Level 1 Accept is called L1A both located on the BCM tab.